By keeping pushed one of the two keys (
or
) for a time shorter than 2 seconds, the change of
parameter will be by one step corresponding to 1 hour a press.
For a rapid change the operator has to keep one of the two keys (
or
) pushed for a time
longer than 2 seconds. In this case the change of parameter will be by 10 steps correspondent to
10 hours a second until the release of the key.
Press
key to confirm entry and pass to programming of minutes.
On display now you will see the two numbers on the right side of the dot (showing minutes )
still while the two numbers on the left side of the dot (showing the hours) flashing.
The modification of this parameter (range of programming 00/59 minutes) is done by using
key
(to increase value) and
key(to decrease value).
By keeping pushed one of the two keys (
or
) for a time shorter than 2 seconds, the change of
parameter will be by one step corresponding to 1 minute a press.
For a rapid change the operator has to keep one of the two keys (
or
) pushed for a time
longer than 2 seconds. In this case the change of parameter will be by 10 steps correspondent to
a 10 minutes a second until the release of the key.
In case a value equal to 00.00 is set, the time of boiling is not included.
Press
key to confirm data entry. The word OFF appears on the display.
3.4.1 START UP PROGRAMMING
After having programmed the cycle there are two options for the operator:
-
immediate switching on
-
deferred switching on
During programming of start-up the red leg of
key flashes intermittently.
- Immediate switching on
Polymerizing unit on OFF: press the START/STOP key.
Four zeroes separated by a dot will appear on display.
Press the START/STOP key twice (2 times) and the cycle is activated immediately.
- Deferred switching on
Polymerizing unit on OFF: press the START/STOP key.
Four zeroes separated by a dot will appear on display.
The two still zeroes on the left side of the dot indicate the hours while the two flashing
zeroes on the right side of the dot indicate the minutes.
The first parameter to change are the hours.
The modification of this parameter (programming range 00/99 hours ) is done by using
key (to
increase value) and
key (to decrease value).
By keeping pushed one of the two keys (
or
) for a time shorter than 2 seconds, the change of
parameter will be by one step corresponding to 1 hour a press.
For a rapid change the operator has to keep one of the two keys (
or
) pushed for a time
longer than 2 seconds. In this case the change of parameter will be by 10 steps correspondent to
a 10 hours a second until the release of the key.
Press the START/STOP key to confirm entry and to go to programming of minutes.
On display now you will see two still numbers on the right side of the dot (indicating the
minutes) while the two numbers on the left side of the dot (indicating the hours) are flashing.
The modification of this parameter (programming range 00/59 minutes) is done by pressing the
key (to increase value) and
key (to decrease value).
- Page 6/9 -
