SIDE I WARNINGS, PRECAUTIONS AND GENERAL ADVICES
1.1.1 WARNINGS
Before connecting the plug of the POLYMERIZING UNIT OMEC TYPE PL.06.00 - PL.12.00 to the
current intake check the feeding voltage. It must be the same as the voltage written on the
machine plate.
I.G.: machine VOLT 230 - HZ 50 = feeding voltage VOLT 230-HZ 50.
1.1.2 PRECAUTIONS
a)
The OMEC POLYMERIZING UNIT TYPE PL.06.00 - PL.12.00 must be used ONLY AND EXCLUSIVELY
for the polymerization of the acrylic components of fixed and movable dental prosthesis
and skeletal prosthesis.
b)
It is compulsory to wear protection glasses and gloves during the use of the
POLYMERIZING UNIT TYPE PL.06.00 - PL.12.00.
c)
Before inspection and checking inside the unit, take out the plug connecting the
machine to the current and disconnect it from the hydro net.
d)
It is absolutely forbidden to use the POLYMERIZING UNIT TYPE PL.06.00 - PL.12.00 without
water. Be sure your own electric plant complies with the 2006/95/EC - Low Voltage.
OMEC IS NOT GUILTY FOR A WRONG OR IMPROPER USE OF ITS POLYMERIZING UNIT
TYPE PL.06.00 - PL.12.00
1.1.3 GENERAL ADVICE
a)
On receiving the machine check the package integrity and then make sure that the
machine is perfect and not damaged (due to bad carrying).
b)
Follow carefully the instructions for installing the machine.
c)
The OMEC POLYMERIZING UNIT TYPE PL.06.00 - PL.12.00 must be used only by a skilled
worker, and therefore use the machine ONLY AFTER HAVING READ CAREFULLY and understood
the instruction and maintenance hand-book.
d)
The OMEC POLYMERIZING UNIT TYPE PL.06.00 - PL.12.00 is supplied complete with the
following accessories:
e)
No. 1 INSTRUCTION HAND-BOOK which must ALWAYS GO TOGETHER with the machine even if it
sold as a second-hand machine
f)
No. 1 WARRANTY CERTIFICATE
g)
No. 1 CONFORMITY DECLARATION
SIDE II PRODUCT DESCRIPTION
2.1.1 TECHNICAL DATA
The POLYMERIZING UNIT allows to program a cycle composed by two working phases (phase no 1 =
preheating – phase no. 2 = boiling) thanks to free data input among the programming ranges and
according to the operator’s needs. Moreover the operator has the opportunity to choose between
an immediate switching on and a postponed one (timer phase).
Programmable Data
Programming Range
Timer
Clock (hrs.min.)
From 00.00 (hrs.min.) to 99 hrs. and 59 min.
Temperature
From 0°C to 100°C
Rising speed
From 0 to FULL (max speed)
Phases 1
(Preheating)
Holding time
From 00.00 (hrs.min.) to 20.59 (hrs.min)
Temperature
From Phase 1 temperature to FULL (boiling temperature)
Rising speed
From 0 to FULL (max speed)
Phase 2
(Boiling)
Holding time
From 00.00 (hrs.min.) to 20.59 (hrs.min.)
- Page 1/9 -
