11
3. Unscrew any of the two black (M) small knobs making sure not to unscrew it completely from its seat (S);
4.
Bring the white sliding block (P) close to the blade (L) until they come very close;
5.
Evaluate the thickness of the sliding block (the sliding blocks of the blade guide continuously wear; they
have to be replaced when their thickness is below 1.5 cm) and, if necessary, replace it with a new sliding
block;
6. Re-screw the small knob (M) up to lock the sliding block (P);
7. Repeat the operations from 1 to 6 for the other unit knob/sliding block;
[K] OPTIONAL falling meat pusher.
BLADE GUIDE HEIGHT ADJUSTMENT
8.
Make sure that the machine is switched off (rotational device positioned “O” = OFF);
9. Make sure that the machine is not working (blade has stopped);
10. Unscrew the black knob (N) (located opposite to the working table of the operator) which, through its
integral screw, blocks the rod (A) of the blade guide (G) coming out from upper part of the machine and the
working table; in this way, the rod (A) of the blade guide (G) can run vertically;
11. Adjust the height of the blade guide (G) according to the height of the material to cut (max. 1 cm above it);
12. Screw the small knob (N) to block the rod (A) of the blade guide (G), the blade guide (G) and the protection
(R) is necessary to them, at the desired height;
[K] OPTIONAL falling meat pusher.
BLADE TENSION ADJUSTMENT
13.
Make sure that the machine is switched off (rotational device positioned “O” = OFF);
14. Make sure that the machine is not working (blade has stopped);
15. Screw the black knob (T) located on top to increase the blade tension and unscrew to decrease the blade
tension; it is not necessary to open the door or unscrew the pulley to perform this adjustment;
16. Screw the black knob (T) so that the white line on the neck of the knob is very close to the frame of the
bone band saw (as per photo of the back side of the bone band saw);
17. Always check the blade tension when the machine is not working before restarting it (before restarting the
motor);
(K) OPTIONAL falling meat pusher.
Installation
