Omcan BE-IT-710-CSS, Instruction Manual

Page: 9 / 28

9
Installation
any case, are shipped in a single packaging with the machine) and with the worktables completely raised. It
is blocked on the floor of the vehicle, pallet or crate with appropriately dimensioned cross members and/or
wooden blocks and/or tied to adequately robust points on the vehicles. Use a forklift with adequate capacity for
lifting and handling the pallet or crate (the weight is specified in the technical specifications, as well as on the
machine ID plate); the truck forks must be inserted into the provided seats in the base of the pallet or crate/box
and must protrude by at least 250 mm from the opposite side. Free the machine from the packaging, sort the
materials by type (plastic, wood, etc,.) and take them to collection points that are accessible only to authorised
persons and then organise their disposal in accordance with the laws in force. Check that the machine and its
parts are integral; contact the manufacturer in case of doubt.
All the packaging removal, handling and positioning operations must and can only be performed
by expert persons (mechanics, trained forklift drivers) wearing protective footwear with reinforced
toecaps and puncture-resistant soles (because of the possible presence of nails), work gloves with
good resistance to abrasion and protective helmet.
ATTENTION
The use of pallet and crate handling systems and/or devices other than those described is forbidden.
Take every possible precaution when handling and/or moving the machine or its parts in order to
prevent the insurgence of risks for persons, animals and property, or reduce it to the greatest extent
possible.
Raise the machine only the minimum necessary, and prevent shocks, and then lay it down as soon as
possible; as soon as it is on the ground the machine can be moved simply by pushing as it is fitted with 4
wheels.
ATTENTION
When moving the machine on the wheels the worktables must be in the lowered position and, if required (e.g.
for saving parking space), should only be raised at the last moment. Moving the machine on its wheels with the
worktables raised can give rise to the risk of overturning or falls to the ground (e.g. if it bumps into obstacles on
the ground or one wheel goes into a hole in the floor), with the consequent possibility of impact or contusions,
even serious ones, for any exposed persons.
When positioning the machine to use it, leave enough room around it not only for mere production activities
but also for any other operation such as cleaning; it is normally sufficient to leave 1000 mm of free space per
side unless the machine borders an escape route, in which case at least 1200 mm of free space must be left.
All the doors in the vicinity or the machine must be easy to open and free from obstacles; the same applies
to the doors and hatches of furniture, equipment, machinery, etc. Block the two feet to ground, screwing them
in such a way that when they press on the floor they lift the machine just enough to take the weight off the
nearby wheels (do not leave it resting on wheels only as it would wobble anomalously when in operation). If it
is necessary to move the machine (for cleaning purposes, for example), simply let it rest on the four wheels;
unscrew the feet until there is absolutely no load on them.
ELECTRICAL CONNECTION
All operations of an electrical nature regarding the machine and/or the place of work must be performed by