Omcan BE-IT-710-CSS, Instruction Manual

Page: 12 / 28

12
Operation
TURNING THE MACHINE ON AND OFF
To turn on the machine, connect it to an electricity socket and then turn the main switch to I - ON. Turn it off by
means of the main switch, turning it to position O - OFF.
PREPARING THE MACHINE FOR WORK
• Put the worktables in the horizontal work position; lower the guards completely.
• Position the flour tray and fill it with the strictly necessary quantity of flour.
• Turn on the machine.
• Keep the rolling pin ready for winding the final sheet.
HOW TO SET THE WORKTABLES IN THE WORK POSITION
Wear clean work gloves and safety footwear with reinforced toecaps.
The operation can be performed by a single operator, only on machines with worktables measuring a maximum
of 950mm; greater lengths require the simultaneous intervention of two people in order to prevent exposure to
high risk of an ergonomic nature with possible muscle-skeletal lesions. Proceed as follows in order to take the
worktable to the work position:
• Support the worktable with one hand and push it forward slightly.
• For worktables with length ≤ 950mm: using the other hand the operator must make the support come out
from the top supports and lower the table, making the support enter the lower supports
• For worktables with length > 950mm: the second operator must make the support come out from the top
supports and, while the worktable is lowered slowly, make it enter well into the bottom supports.
Check that the waste collection trays have been inserted and locked properly and that the middle waste
collection drawer is positioned correctly under the sheeting zone.
POSITIONING THE FLOUR TRAY IN THE MACHINE
The tray should be inserted between the round bars.
TRAYS AND CENTRAL WASTE COLLECTION DRAWER
Wear safety footwear with reinforced toecaps and abrasion-proof gloves.
The waste collection trays (one for each worktable) should only be extracted in order to empty and clean them,
and put back into the machines immediately afterwards. For cleaning consult the maintenance section.
IMPORTANT! Using the machine without the waste collection trays and the drawer positioned correctly
is forbidden.
In order to remove a waste collection, unscrew the screws with knob (one per side) that keep it locked, and
extract it from under the table. The extension is not fixed to the waste collection tray but only slotted to the end
of it, and is easy to separate from the same. In order to fit a waste collection tray back, insert it into the guides
under the worktable, push it fully in as far as it goes and lock it by screwing in the screws with knob (after