400715D-EN
30
7.
Rinse the
nozzle body
with clean water, then air dry.
8.
Examine the components for wear and damage. If damaged or worn, replace the component.
9.
Install the nozzle body.
Install the Nozzle Body on an A-Jet
• For the Motorized Z-Axis, go to
Install the Nozzle Body on a Motorized Z-Axis
Install the Nozzle Body on a Tilt-A-Jet
.
10.
Install the
mixing tube
. See
Examine the Abrasive Feed Tube
Abrasive feed tubes wear as garnet flows from the hopper to the nozzle assembly. A cracked, worn, wet, or damaged
tube can degrade cutting performance.
Examine the abrasive feed tube daily and replace if needed. For operations that use high volumes of abrasive, examine
the abrasive feed tube daily.
1.
Remove the
abrasive feed tube
from the
hopper
and the
nozzle
.
Figure 2
Summary of Contents for MAXJET 5i 320303 Series
Page 32: ...32 400715D EN...
