400715D-EN
14
5.
Hold the
inlet body
to counteract the torque, then tighten the
nozzle body
.
Figure 15
6.
Install the
mixing tube
. See
7.
Connect the
abrasive feed tube
to the
nozzle
and the
abrasive hopper
, if needed.
Figure 16
Install the Nozzle Body on a Tilt-A-Jet
NOTICE
Remove the mixing tube BEFORE installing or removing the nozzle to prevent damage. Large upward
forces from an installed mixing tube can misalign the internal nozzle components.
1.
Remove the
mixing tube
if it is installed in the
nozzle body
NOTICE
Handle the nozzle carefully to prevent damage to the abrasive tubing retention tube.
Summary of Contents for MAXJET 5i 320303 Series
Page 32: ...32 400715D EN...
