GX41
23
Fig. 32
3
Mounting the Mechanical Stage
(Fig. 32)
}The mechanical stage can be mounted on either the left or right side of
the stage. The following instructions explain how to mount it on the right
side.
1. Align the mechanical stage clamping screws ² with the two mounting
holes @ on the lower part of the right side of the stage and tighten the
screws to attach the mechanical stage.
2. After tightening the screws with your fingers, use a coin or screwdriver to
turn the screws until the mechanical stage is securely attached.
When using as a plain stage
}Mounting the mechanical stage is not necessary if you are going to
observe a large object or if the mechanical stage might obstruct your
view.
In this case, use a stage center plate matching the specimen size as
required.
Fig. 33
4
Mounting the Stage Plate
(Fig. 33)
1. Extend the specimen holder ² to retain the stage plate holder @ on
which the stage plate will be placed.
2. Place the CK40M-CP stage plate ³ on the stage plate holder.
Fig. 34
5
Mounting the Observation Tube
(Fig. 34)
1. Loosen the observation tube clamping knob @ till immediately before it
slips out of the hole.
2. Insert the circular dovetail at the bottom of the observation tube into the
mount opening on the microscope frame. Adjust the observation tube
until the binocular eyepieces face directly to the front, and then tighten
the clamping knob.
@
²
³ @
²
@
Summary of Contents for GX41
Page 4: ......
