Olympus GLIDER, User Manual

Page: 74 / 80

DMTA029-01EN, Rev. E, December 2017
List of Figures 68
Figure 2-24 Connecting the spring to the mounting bracket ........................................... 32
Figure 2-25 Probe or transducer holder held down by springs on bearing arm ........... 32
Figure 2-26 The screw that holds the yoke on the bearing arm ....................................... 33
Figure 2-27 The screw that holds the yoke parts together ................................................ 34
Figure 2-28 Unscrewing the transducer .............................................................................. 34
Figure 2-29 The screw that holds the yoke parts together ................................................ 36
Figure 2-30 Removing the probe from the wedge ............................................................. 36
Figure 2-31 Removing the encoder screws ......................................................................... 37
Figure 2-32 Removing the encoder ...................................................................................... 38
Figure 2-33 Removing the axis .............................................................................................. 39
Figure 2-34 Aligning the new axis ........................................................................................ 39
Figure 2-35 Turning the increment knob to move axis into the module ........................ 40
Figure 2-36 The axis passed completely through the encoder module .......................... 40
Figure 2-37 Loosening the pivot lock on a pod (manual type shown) ........................... 41
Figure 2-38 Attaching manual suction cups to the inspection surface ........................... 42
Figure 2-39 Tightening the thumbscrew on the Y-axis support ....................................... 43
Figure 2-40 Disengaging a manual-type suction cup from the surface .......................... 43
Figure 2-41 Magnetic-activation lever in the “off” position ............................................. 44
Figure 2-42 Magnetic-activation lever in the “on” position ............................................. 45
Figure 2-43 Scanner setup ...................................................................................................... 46
Figure 3-1 Knob engages inwards to lock the X-axis ....................................................... 50
Figure 3-2 The increment knob in the free-running position ......................................... 50
Figure 3-3 Making the inspection pass with the Y-axis module .................................... 51
Figure 3-4 Pull out the knob to unlock the X-axis ............................................................ 51
Figure 3-5 Turning the increment knob ............................................................................. 52
Figure 4-1 Pinout for EWIX1415 cable ............................................................................... 55
Figure 5-1 Yoke geometry .................................................................................................... 57
Figure 5-2 Exploded view .................................................................................................... 60