DMTA029-01EN, Rev. E, December 2017
Scanner Assembly and Setup
45
4.
When you are satisfied with the scanner position, turn the magnetic-activation
lever to the “on” position (see Figure 2-42 on page 45).
Figure 2
‑
42 Magnetic
‑
activation lever in the “on” position
5.
Check the holding force of each magnetic pod.
If a pod is not holding strongly enough, release it, and then repeat the
optimization of the contact area between the pod and the surface to firmly attach
the pod to the surface.
If you aren’t able to achieve a good holding force with the pod, do not use the scanner
on a surface that has a steep slope. Otherwise, equipment damage or personal injuries
may result.
6.
Set the Y-axis level:
a)
Loosen the thumbscrew used to lock the Y-axis support.
b)
Adjust the level of the Y-axis.
c)
When the Y-axis is level, tighten the thumbscrew (see Figure 2-39 on page 43).
7.
Tighten the pivot locks on the two mounting pods.
WARNING
Summary of Contents for GLIDER
