184
Troubleshooting (Cont.)
Chapter 12
5
The card access lamp
blinks after shooting in
the mode.
6
There is a problem with
the card.
7
The card is full.
8
The batteries ran out of
power.
9
The control panel/
monitor indications
disappear, or only the
battery check blinks.
0
A write-protect
adhesive seal is placed
on the card or there is
no card in the camera.
5
The recorded movie image
data is being written to the
card. You can start shooting
again when the card access
lamp stops blinking.
6
See the error code chart.
7
Replace the card or delete
unwanted pictures, etc.
8
Replace the batteries with
new ones.
9
Replace the batteries with
new ones. (Do not open the
battery compartment cover
when the card access lamp
is blinking.)
0
Insert a new card in the
camera.
P. 78
P. 190
P. 29, 130,
131
P. 25
P. 25
P. 29
POSSIBLE CAUSES
CORRECTIVE ACTION
REF. PAGE
No picture is taken when the shutter button is pressed.
The date recorded with the image data is wrong.
1
The date is not set.
2
The camera has been
left for approx. 1 hour
with the batteries
removed and the date
setting is canceled.
1
Set the date. The clock
adjustment is not factory-
preset.
2
Set the date again.
P. 32
P. 32
