Olympus C-2020ZOOM - CAMEDIA - Digital Camera, Instructions Manual

Page: 191 / 204

191
The flash does not fire.
1
The flash mode was set to the Off mode.
[
Check the flash mode before shooting. (P. 57)
2
The subject is lighted.
[
Set the flash to Fill-In mode. (P. 57/59)
The pictures already taken do not appear on the LCD monitor.
1
The camera is in the Record mode.
[
Set the Mode dial to . (P. 92/132)
2
There is no picture in the card.
[
NO PICTURE appears on the LCD monitor. (P. 92)
3
There is a problem with the card.
[
See the Error code chart. (P. 195)
The LCD monitor is hard to read.
1
The brightness may be incorrectly set.
[ Adjust the brightness. (P. 183)
2
It is under sunlight.
[
Block the sunlight.
3
The LCD monitor is broken.
[
Have it repaired.
When the camera is connected to a computer, an error message
appears while data is being transferred to the computer.
1
The cable is not plugged in correctly.
[
Connect the cable correctly. (P. 160)
2
The power is OFF.
[
Set the Mode dial to turn on the power. (P. 161)
3
The batteries are exhausted.
[
Replace the batteries with new ones (P. 24) or use the optional
AC adapter (P. 26).
4
The serial port is not selected correctly.
[ Use the operating system software to make sure the serial port is
selected correctly.
5
There is no available serial port.
[
Make one available by following the computer’s instructions.