Page 1-3
OLYMPIC SMART SCALE
®
Model 20/25
Installation
2. Lift tray straight up (
Fig. 1D
).
To attach the tray:
1. Lower tray so four feet fit into tray mounts.
2. Securely tighten all four Phillips screws (
Fig. 1C
).
Initial Battery Charge
The Smart Scale has an internal rechargeable battery pack that
automatically charges when it is connected to a wall outlet. Before
the scale is battery operated for the first time, the batteries should
be charged for approximately 2.5 hours.
Electrical Requirements
CAUTION: This product must be connected directly to
a hospital-grade electrical outlet.
These products are rated at 120 Vac, 60 Hz, 2 amps. A 9-ft. (2.8 m)
long power cord is included.
Products may be ordered that are rated at 220/240 Vac, 50/60 Hz,
0.1 amps. They will be shipped without a plug. Install the proper
connector according to the following wire description:
Black:
AC high
White:
AC low (neutral)
Green:
Chassis ground
Battery Operation
The scale can also be powered by its internal rechargeable battery
pack consisting of six sub-c NiCad batteries rated at 7.2 Vac
(1.2 Vac per cell).
For information on replacing the battery pack, see
Replacing the
Battery Pack
on page 3-11.
Fig. 1D
Tray
Tray
Feet (4)
Tray Mounts (4)
220/240 Vac products
are not UL or CSA certified.
Summary of Contents for SMART SCALE 20
