Olympia Protect 9 Series, Operating Manual

Page: 31 / 40

Monitoring Functions
G
31
Emergency Call (SOS)
You can trigger the SOS (emergency call) function by
pressing the
button on the base unit or the but­
ton on the remote control unit, depending on the configura­
tion.
The GSM dialling unit is activated when phone numbers are
stored. The emergency call number is dialled first, then up
to 10 stored phone numbers in succession . A voice mes­
sage requests the subscriber answering to press the
[1]
button on their phone.
The handsfree function of the base unit is activated and
enables communication between the caller and subscriber
called.
There are three ways to end the SOS function:

Enter your 4-digit PIN on the base unit and confirm it by
pressing the
button.

Press the button on the remote control.
or

The subscriber called takes the call, executes a function
within 24 seconds and then ends the call.
Remote Access Via Telephone
The wireless alarm system can be operated by remote ac­
cess using a telephone.
1. Dial the mobile phone number of the SIM card installed
in the alarm system.
2. Wait until the alarm system takes your call. A longer
acoustic signal is issued.
3. Enter the 4-digit PIN of the base unit . Two short
acoustic tones are issued.
4. Complete various functions using the phone's keypad
(refer to the table). The monitoring functions are con­
firmed by a voice message.
Key Function
[1] Activate the handsfree function
[2] Activate call screening
[3] Activate Alarm mode
[4] Activate At Home mode
[5] Activate Silent mode
[6] Activate Disarmed mode
[#] End the handsfree or screening function
[#], [#] End remote access via telephone facility