Olympia Protect 9 Series, Operating Manual

Page: 24 / 40

Configuration
G
24
Trigger Delay
You can define that the alarm to be triggered should be ac­
tually sounded after a delay.
This provides you with sufficient time to enter your apart­
ment or house and disarm the alarm system.
You can set a trigger delay between 0 and 240 seconds.
If one of the sensors is tripped, the system must be
switched to be disarmed for this period so that no alarm is
triggered.
You can select whether an acoustic signal should be issued
from the base unit during this period or not.
1. Enter your PIN. Confirm it by pressing .
2. Press to open the menu.
3. Select the Trigger Delay menu option.
Confirm it by pressing .
4. Select the Duration menu option.
Confirm it by pressing .
5. Use the and buttons to set the required
delay time.
6. Confirm it by pressing the button.
7. Select the Trigger Tone menu option.
Confirm it by pressing .
8. Set the trigger delay tone with the and
and switch it Off or On .
Confirm it by pressing the button.
Arming Delay
You can set the alarm system to be armed following a de­
fined delay.
This provides you with sufficient time to leave your apart­
ment or house through the alarm-protected front door be­
fore the alarm system is actually armed.
You can set an activation delay between 0 and 240 sec­
onds.
During the delay period, you will hear a signal tone issued
at intervals of one second.
1. Enter your PIN. Confirm it by pressing .
2. Press to open the menu.
3. Select the Arming Delay menu option.
Confirm it by pressing .
4. Use the and buttons to set the required
delay time. Confirm it by pressing .
Alarm Period
The base unit is equipped with an integrated siren.
The duration of the acoustic alarm can be selected be­
tween a minimum of 1 minute to a maximum of 10 minutes.
The standard setting for the alarm period is 3 minutes.
1. Enter your PIN. Confirm it by pressing .
2. Press to open the menu.
3. Select the Alarm period menu option.
Confirm it by pressing .