Olympia Protect 9 Series, Operating Manual

Page: 11 / 40

Installation
G
11
The use of batteries serves as a safeguard against fail­
ure. In the case of normal power supply using the power
adapter plug, the batteries are not affected. In the event
of a power failure, the base unit is battery powered until
the power supply is restored.
7. Set the Antenna switch to Int .
8. Connect the power adapter plug to the base unit.
9. Place the cover on the battery and connection socket
compartment and tighten the screw in the battery and
connection socket compartment.
Positioning the Base Unit
It is possible to setup the device in a user-friendly, inclined
position on a table or desk. To do this, insert the two
legs (1) supplied in the recesses for the wall installation
bracket (2) on the rear of the base unit.
1
Installing the Base Unit on a Wall
After having found a suitable location for the base unit, you
can begin with the installation.

WARNING!
• Risk of fatal injury through electric shock or gas explo­
sion!

During installation, pay attention to the possibility of elec­
trical cables and gas pipes running in the walls.

Pay attention that you do not damage electric cables or
gas pipes.
1. At the installation location, insert two screws in the wall,
100 mm apart and aligned horizontally. (It may be nec­
essary to drill the holes first and then insert dowels in
which to tighten the screws, depending on the properties
of the wall.)
2. Screw the screws in the wall using a screwdriver until
there is approx. 3 mm clearance from the bottom edge
of the screw head to the wall.
3. Hook the recesses in the wall bracket (2) for the base
unit over the screws.
4. Plug the power adapter in a properly installed power
socket. The base unit is then ready to use.
2