Connecting the Camera
Registering the Receiver on the Alarm System
G
14
3. Connect the power adapter to the power connection
port (17) on the receiver and a properly installed, easily
accessible power socket.
The LEDs on the network connection port (10) signal
when a connection exists to the network (lights up
orange) and that data is being transmitted (flashes
green).
ATTENTION!
Property damage is possible!
The camera could be damaged if you move the ser
vomotors by hand or interrupt the movement.
Avoid moving the servomotors by hand or interrupt
ing the movement of the camera.
4. The servomotors of the camera are controlled automati
cally. Wait until the process has finished.
Registering the Receiver on the Alarm
System
After connecting the power supply and network to the re
ceiver, you must register the receiver on the base unit of
the alarm system.
1. Disconnect the power cable of the camera from the
power socket on the receiver.
2. Select the
Register
menu option on the alarm system.
To configure the alarm system, please refer to the
manual supplied with the alarm system.
3. Connect the power cable of the camera to the power
socket on the receiver.
4. When the message
Siren
followed by a number ap
pears in the alarm system display, registration on the
alarm system was completed successfully.
Change the
Siren
entry to
Camera
, for example, us
ing the alarm system menu.
5. The receiver is now registered on the alarm system and
can receive signals from the alarm system. In the event
of an alarm, the red LED (19) on the rear of the receiver
indicates that an active connection between the alarm
system and receiver exists.
