![background image](http://html.mh-extra.com/html/olympia/carrera-de-luxe-md/carrera-de-luxe-md_service-manual_732750033.webp)
4.4.3 Hammer Position Adjustment
Check:
The centerline of the hammer and the centerline of the spoke
(printwheel) must match.
Adjustment:
1) Enter adjustment mode.
While holding down the code key, press the express key to
activate the selection motor. (Refer to 4.3.2 "Selection Motor
Home Position and Hammer Position Adjustment Mode".)
2) Loosen the two screws (2) holding the hammer bracket (1-A) in
place.
3) Slide the hammer bracket (1-A) left or right so that the centerline
of the hammer (1-B) is lined up with the centerline of the spoke
(printwheel) (3-A).
Note:
Fix the hammer (1-B) in a position so that if you gently move the
spoke (printwheel) (3-A) with your finger, the spoke moves the
same amount to the left and right.
Confirmation:
Move the selection motor one character (two steps) at a time (refer
to 4.3.2 "Selection Motor Home Position and Hammer Position
Adjustment Mode") and make sure that the centerline of each
spoke on the printwheel (3-A) matches the centerline of the
hammer (1-B).
Possible Symptoms:
"||" or an incorrect character is printed.
This can cause the printwheel spokes to be bent or damaged.
4-7
Summary of Contents for Carrera De Luxe MD
