14.
Position rear Window Wall Panel into place on plywood floor. Butt both vertical wall studs of side
and rear walls together and attach with
3 - 2 1/2” screws
. Screw at the bottom, middle and top of
stud to secure properly.
Rear Window W
all
Side Solid W
all
Important:
Make sure all walls are
aligned in their upright position. If
not ,water may leak into your shed.
Unsure if panel is facing up or
down? check siding on window wall
panel to match alignment.
13.
Starting at Rear Corner, position a Solid Wall Panel on top of plywood floor. Make sure panel is
facing up. The side wall panels will sit flush with floor frame with the front and rear panels sandwiched
between them.
Note:
siding will overhang the floor by approx. 1/2”.
2x3 Plate of wall panel is
flush with floor frame. Siding
overhangs floor by 1/2”.
Side Wall Panel
Rear of Shed
Rear of Shed
Bottom Wall Plate
12.
Starting with
Solid Wall Panels
, carefully lay panel face down. Position and attach
Wall Plate
to bottom of wall studs of each wall panel with
3 - 2 1/2” screws
. Position so plates are flush with
framing.
Note:
bottom Wall Plates may already be attached to some Solid Walls.
B. Wall Section
Important:
Pilot hole
ALL
2x3 Wall Studs
with 1/8” drill bit prior to screwing.
This will make it much easier to
attached together.
Pilot
Hole Plate
first.
Optional:
Small bead of
Caulk on wall
frame first.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 11
