Olivetti PR2 plus, Service Manual

Page: 87 / 179

Service Manual 683311W 4-35
4.6.3 ADJUSTING THE TOF OF FORM (TOF)
This adjustment sets the distance between the form's TOF and the first print line.
The adjustment can only be activated if the "TOP MARGIN PR40 LIKE" parameter in the PR40+
emulation setup has been set to "N".
Proceed as follows to make this adjustment:
1. Power on the printer with its cover open and while holding down the three console keys.
2. Wait for an acoustic signal to indicate that the printer has switched into the adjustment procedure
and close the cover.
3. Press the "Local" key.
4. Press the "Station 1" key.
5. The three console keys are activated after this phase. The "Station 1" key can be used to reduce
the TOF while "Station 2" can be used to increase it.
6. Insert an A4 sheet of paper into the front slot to check the status of the current TOF. This check
is made by printing a specific test. If the current TOF value is too high, printing may occur off the
sheet of paper.
7. Press "Station 1" and/or "Station 2" to decrease or increase the TOF.
8. Repeat steps 6. and 7. until the adjustments are completed.
9. Press the "Local" key to permanently store the TOF and to automatically move on to the next
adjustment.