Basic Operation
BASIC OPERATION GUIDE
3-19
Auto Sleep Mode
Auto Sleep
mode puts the machine into a state of sleep if no operation has
been performed for a preset period of time. The factory default setting is
30 minutes (16 and 20 ppm models) and 45 minutes (25 ppm model).
Time that can be set:
•
Inch Specification — 1 to 240 minutes (in 1 minute increments)
•
Metric Specification — 1 to 120 minutes (in 1 minute increments)
NOTE:
It is possible to set the amount of time before
Auto Sleep
mode
engages. For details, refer to
Chapter 3
,
Advanced Operation Guide
.
It is possible to engage
Auto Sleep
mode manually:
1
Press
[Power]
.
Auto Sleep
mode
engages immediately.
Only the
Main Power
indicator is
lit, all other indicators are off.
Consumed power is this mode is
less than in
Low Power
mode
2
To enable copying again, press
[Power]
. Power is restored within
approximately 20 seconds.
NOTE:
In
Auto Sleep
mode, if the machine receives print or fax data it
will automatically engage and output the data.
Summary of Contents for d-Copia 16MF
