Olivetti CopyLab 200, User Manual

Page: 35 / 53

Preventive Maintenance 35
Preventive Maintenance
The machine is designed to require minimum maintenance. Some simple operations should however be carried out
regularly so as to ensure its correct functioning.
General Care
Safety
The machine and its supplies were designed and tested to meet strict safety requirements that ensure they conform
to the safety and environmental protection regulations laid down by the competent authorities.
All instructions and warnings given on the machine or provided together with it
must be respected .
Symbol:
!
= Warning
The machine has an energy saving feature that reduces the consumption of current when it is idle. The machine
may be left permanently on.
The machine is to be connected to a power supply of the type indicated on the data plate. If you are not sure of the
type of power supply available, call your local electricity board.
The machine is to be installed close to an independent, easily accessible electrical power socket.
•
Do not place any object on its power cable.
•
Do not position the machine in such a way that the cable could get trodden on.
The ON/OFF switch does not remove all power from the machine. The power cable should be unplugged to
ensure that no power is present inside the machine.
The use of extensions and adapters is not recommended and should therefore be avoided.
Use
‰
Location
To ensure that the machine operates reliably and provides a satisfactory copying quality, you should:
•
Place the machine on a flat, uniform surface in a well-ventilated room, close to an independent electrical power
socket and in such a way that all its parts are easily accessible.
−
Do not place the machine on trolleys or unstable surfaces or supports.
−
Do not place the machine close to or on top of radiators.
−
Do not install the machine inside other systems without adequate ventilation.
−
Do not use the machine near water, in other damp places or outdoor environments.
•
Recommended environmental conditions:
–
Temperature: from 15° to 35° C / from 60
°
to 95
°
F.
– Humidity: from 20% to 80%.
Avoid installing the printer in a place where it is exposed to:
– Direct
sunlight.
– Sudden changes in temperature or humidity.
‰
Care
•
Do not remove the print head from the machine unless you wish to replace it.
•
Do not place heavy objects, clips or staples on the machine’s surfaces.
•
Do not pour liquids of any kind onto the machine.
•
Always keep the cover closed irrespective of whether the system is working or idle.
•
Avoid staring at the scanner lamps: these lamps produce an intense light which will not damage your eyesight but
may cause temporarily impaired vision.