Olivetti 3D S2, Service Manual

Page: 28 / 112

3-6 Service Manual Y118040-3
9. With a spirit level, ensure that the printer is level in the X axis (Figure 3-10) and Y axis (Figure 3-11) directions.
Figure 3-10
Figure 3-11
PRINTER PREPARATION
This Chapter describes the procedures necessary for correctly configuring and preparing the Olivetti
3D-S2 printer for printing.
Unblocking the hot-end group
To protect the printer during shipping, the hot-end group is anchored to the centre of the Z axis (at the machine
rear) using two packing straps. Before attempting to use the printer you must therefore unblock the hot-end
group by removing these straps.
Figure 3-12
Powering on the printer
Connect the printer to a 220V electrical outlet using the power cord provided and power it on at the power switch.
LCD Display
When the printer is powered on, the LCD display illuminates.
On the display is shown the most important printer status information.
Loading the filament bobbins
See the Chapter
”Loading the Bobbins with Filaments”
.
Cut packing straps