Oliver 4275C, Owner'S Manual

Page: 23 / 70

4275C Jointer OLIVERMACHINERY.NET 23 | Page
Install Batteries for Digital Readout
Locate the digital readout on the control panel. Remove the battery
cover and install two AA-sized batteries.
Install Cutterhead Guard
1. Loosen the fence tilt lock and use the handle
to raise the fence above the table. Lock the
fence in place. Release the fence position
lock, and move the fence all the way back.
2. Insert cutterhead guard shaft into the hole
on the rabbeting table.
3. The guard must be installed as low as
possible, such that it can swing freely
without scratching the table.
4. There is a spring-loaded knob at the bottom
of the rabbeting table. It has a cap screw that
grabs the cutterhead guard shaft and keeps
the guard pushing against the fence.
Rotate the knob counterclockwise until you
can feel the tension from the spring, then
rotate it for another 1/3 turn. Hold the knob
in position and tighten the cap screw.
NOTICE : There are four screw holes on the
knob. If the cap screw gets in the way while
the knob rotates, relocate the screw so the
cutterhead guard can rotate freely.
5. Positioned the fence at the rear edge of the
jointer table. Ensure the guard is pressing
against the fence, and it will spring back to
its original position after it is rotated away.
WARNING
Always operate this jointer with a cutterhead guard, except for some rabbeting
operations. Serious personal injury may occur when operating a jointer without a
cutterhead guard.