Olicom CrossFire 8600, Manual To Operations

Page: 159 / 250

143
CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641 Switch Configuration
Reset Port Address Table
Selecting this command clears all address table entries for a specified port (user is
queried for which port to reset), sets port traffic counters to zero, and sets Time
Since Last Reset for this port to zero.
Clear Non-Volatile RAM
Selecting this command will erase all user-configured parameters (rate, IP address
information, CrossLink, Virtual Token-Ring Switch, STP) and reset the switch.
➽
Note: Clearing NVRAM (non-volatile RAM) erases all configuration parameters.
Follow these guidelines if you must clear NVRAM:
•
If you are using the CrossLink feature, be sure to disconnect the affected
ports—or disable them on the Port Configuration screen and reset the
switch—before clearing NVRAM.
•
If you are using the STP option, be aware that port costs and priorities will be
lost, which may result in loops. Use the menus to reestablish port costs and
priorities, then reset the switch to make the new parameters take effect.
•
If you are using an SNMP manager, you will need to reconfigure all IP and
SNMP parameters.
Power-On Diagnostics
This is a selectable option that determines whether diagnostics are, or are not,
initiated during a switch power-on sequence. To change the selection, highlight the
item and press
ENTER
; then select Enabled or Disabled, and press
ENTER
.
Default: Enabled
❏