Page 30
DH3 WIRELESS GATEWAY
USER GUIDE
NOTE:
Once a new Battery Pack is installed, it is perfectly normal to get a
reading of 3.2 to 3.3 V. This is due to the fact that the WT Series
Transmitters take battery level while it is under load, providing a reliable
method of monitoring battery health. Using the RF Timeout and RF Refresh
tags along with battery voltage for monitoring device and RF
communication health is strongly recommended.
If a new Battery Pack has been kept under storage or initially installed,
battery level may need to be read a couple of times to ensure a stable
accurate reading.
Replace Battery if reading is less than 2.9 V.
Battery Depletion Chart from 2.9 V
9.
Select RTD Wire Type
a.
Select RTD wiring mode that matches the Sensor (2, 3 or 4)
b.
4-wire type is factory default for Direct Mount version “RT1”
c.
Click
Finish
10.
Confirm Transmitter Addition
Battery Voltage
Tx Interval
Duration Before Failure
2.9 V
1-minute
2 days
2.9 V
5-minute
10 days
2.9 V
10-minute
20 days
2.9 V
15-minute
30 days
