Oldham DL9, Instruction Manual And User Handbook

Page: 6 / 11

6
 Reassembling the bezel ring
1. When the lens is in position over the
reflector, the bezel ring is screwed onto the
headpiece housing, and locked in position by
the stainless steel cable lock.
2. Ensure the cut-outs in the bezel ring line up
with the cable lock.
3. Hook the cable lock into the slot under the
cap hook support. Press down so the cable is
in position, replace the o-ring and then clip
over the boss on the side of the headpiece.
4. Secure with M3x10 mushroom-head screw.
 Replacing the lock barrel
If the lock barrel is damaged it may become
difficult to connect the lamp to the charger. In this
case, the lock barrel must be replaced (M259983
– lock contact spares kit).
1. Undo the M4 lock nut and remove the dome-
head screw that runs through the charging
contact housing.
2. The metal cap-clip can be lifted off and set to
one side (take care not to lose the spring clip).
3. Remove the lock barrel and ensure that the
charging contact housing is clear of any
debris before inserting the replacement lock
barrel.
4. Holding the lock spring in position, refit the
cap-clip cover, insert the dome-head screw
and re-tighten the M4 lock nut.