OKM FS Future GeoSeeker Mini, User Manual

Page: 23 / 52

Operating Modes 23
Use the buttons and to change the number of scan points and confirm by pushing the
button.
All parameters have been adjusted now and you can set up your electrodes according to the screen
shown in figure 5.4. This measurement screen gives information about the position of each electrode.
Progress info: The numbers in the top right corner are indicating how many scan points have been
measured. In the example of figure 5.4 you have to measure 20 scan points in total, whereas 4 scan
points have been measured already.
Marker positions (A, B): This is the place where you get proper information about the upcoming scan
point (the scan point that will be measured after tapping the button). The numbers are indicating
at which cable marker the electrodes have to be placed into the ground. If the number is written in red
color than this value has changed in relation to the previous scan point.
•
A
... is the distance between left Power Electrode and control unit as well as the distance
between control unit and right Power Electrode in terms of distance markers (numbered from 1
to 10). In the example of figure 5.4 you have to place the Power Electrodes at marker “10”.
•
B
… is the distance between left Voltage Electrode and control unit as well as the distance
between control unit and right Voltage Electrode in terms of distance markers (numbered from 1
to 10). In the example of figure 5.4 you have to place the Voltage Electrodes at marker “10”.
OKM GmbH
www.okmmetaldetectors.com
Figure 5.3: Adjusting the number of scan points
Increase scan points
Decrease scan points
Continue
Back to depth screen
Figure 5.4: Adjust marker positions for next scan
Progress info
A = Marker position of
power electrodes
Continue
B = Marker position of
voltage electrodes