Page: 167
Service Guide for PM4410
Chapter C Maintenance Support Function
3. Maintenance mode 2
(1) DIP Switch Settings
DIP SWITCH
DIP SWITCH
DIP SWITCH
DIP SWITCH
Function
4
3
2
1
-
-
O
-
Maintenance information indication enabled
mode
(O: ON, X: OFF, -: ignored)
(2) Operator panel switch Function
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
SWITCH
Function (Valid when DIP switch-2 is ON)
ON-LINE
SHIFT
CONFIG
PATH/
TOF
FF/LOAD
LF
TEAR
PARK
O
O
The LCD displays the maintenance information (total page
number, number of printer characters) for 2 seconds.
(3) Maintenance Information Display Condition
LCD /
Condition
LCD /
Condition
Flash ROM Function
Flash ROM Function
Function
Display Data
Top line
1~8
Displays the value of line feed counter.
Current counter value
Top line
9~16
Displays the value of print counter.
Current counter value
Bottom line
1~8
Displays a correction value for AG centering.
Current counter value
Bottom line
9~16
Reserved
(4) Stored historical page number data
This function counts a page each 11 inch and stores it to EEPROM.
The storage capacity for the counter is 3 byte which equals to pages for 70 years at 20000 pages/ month.
As the printer has no function which is capable of resetting this counter, line feed frequency can be known since the
printer's shipment.
(5)
a) Stored historical printed character number data
This function counts the number of actually printed characters and stores it to EEPROM.
It reads and analyzes the characters from receiving buffer and identifies the characters which has been actually printed
and counts them.
The count of image data for any DPI should be increases by one character each 12 columns,
The storage capacity for the counter is 3 byte which equals to 430 million characters with 256 characters counted as 1
count.
As the printer has the function which is capable of resetting this counter to zero, The usage frequency of print head
ribbon can be known as an index by resetting this counter when replacing a print head and ribbon set.
b) Printed character number counter resetting function
Summary of Contents for Pacemark 4410
