Page: 59
Service Guide for PM4410
Chapter 3 Disassembly
3.3.27 AG Sensor Frame / Start Searching Sensor
(1) Remove Cover Assy Access / Cover Assy Side (R) / Cover Assy Side (L) /Cover Assy Front / Frame Assy Rear /
Plate Front (stuck). (See 3.3.1)
(2) Unscrew 2 screws (1) and remove Rear Plate (2).
(3) Unscrew 2 screws (3) and remove AG Sensor Cover (4).
(4) Unscrew 2 screws (5), unplug the connector (6) and remove AG Sensor Frame (7).
(5) Unscrew the screw (8) and release the latch, then remove Start Searching Sensor Lever Assy (9) and Start
Searching Sensor Cord (10) together.
(6) Unscrew the screw (11) and unplug the connector (12) from I/F Board (CN9), then unplug Start Searching Sensor
Cord (10).
(7) For installation, reverse the removal procedure.
(Note on Installation)
1. In assembling AG sensor frame (7), it should be pulled in the direction of arrow shown in the figure.
2. After assembling the AG sensor frame (7), check the AG plate gap as stated in Section 2 of Chapter 4
ADJUSTMENTS and execute the auto gap correction as stated in Section 3.
Summary of Contents for Pacemark 4410
