4
LF Motor Belt Tension
200 ~ 250gf
(1) Adjust the LF motor belt tension, with the idle pulley
assy, to produce the standard value when the belt is
deflected 1.5 mm at the middle of the LF gear and the
drive pulley B.
5
Slice Level Setting-paper Width Sensor
(1) Install the ribbon cassette only.
(2) Turn on the printer while pressing Switches [9] and
[11] at the operation panel. (This starts the slice level
correction mode - paper width sensor). Confirm
"COMPLETE" is indicated on the LCD. The cover should
be closed during this process.
6
Slice Level Setting-Paper Width Sensor
Notes:
In the following cases, this adjustment should be
implemented:
1) After replacing the Control board. (not required after
ROM replacement).
(1) Set the continuous form (1P, 15 in. wide and 55 Kg)
at the front tractor and also the ribbon cassette.
(2) Turn on the printer while pressing Switches [10] and
[13]. (This starts the paper front edge sensor position
correction mode).
Confirm paper feeding/parking has been repeated 3 times
and then "COMPLETE" is indicated on the LCD.
Notes:
In the following cases, the adjustment should be
implemented.
1) After replacing the Control board. (not required after
ROM replacement).
7
Auto Gap Motor Assy Backlash
J-0.1 mm
(1) Verify the backlash is 0.1 mm between the idle gear
and the adjusting cam.
(2) If adjustment is required, screw down the 2 screws
fixing the auto gap assy, and ensure the backlash
between the idle gear and the adjusting arm.
8
Bail Gear Assy Backlash
K-0.2 mm
(1) Verify the backlash is 0.2 mm between the idle gear A
and the drive gear B, and between the idle gear B and the
idle gear C.
(2) If adjustment is required, screw down the 2 screws
fixing the bail gear assy, and ensure the back lash
between the idle gear A and the drive gear B, and
between the idle gear B and the idle gear C.
Summary of Contents for Pacemark 4410
