127
LP-1040/LP-1040-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu
<Parameter by entering numbers>
0 to 100
Default value = 0, Unit in mm
Paper feed direction
Cut position
Paper feed direction
Cut position
Same Drawing Size with
Top and Bottom Blank = 0 mm
X
Y
printed image
Same Drawing Size with
Top and Bottom Blank ≠ 0 mm
X
Y
a
a
a
printed image
a: Specified value
n
X Offset
n
Y Offset
The parameter specifies the X, and Y offsets. They are valid when the Offset Mode
is set to Offset with Paper Size Change or Offset without Paper Size Change.
The parameter setting is invalid on the conditions below:
- HP-GL data is specified;
-
The image data was created with the image center set to the coordinate origin; and
- The data is printed with setting Page Size to Actual Size.
<Parameter by entering numbers>
-9999.99 to 9999.99
Default value = 0, Unit in mm
n
Writing Mode (only with HP-GL and D-SCAN)
The parameter specifies the overwriting mode when the images overlap. Note
that, with HP-GL data, the writing mode specified with data is prioritized over the
setting with touchpanel.
<Parameter by selecting options>
n
: Default value
n
Overwrite
Overwrites.
Delete and Write
Deletes and writes.