- 34 -
Connecting to a PC
Connecting Cables
This printer can connect to a computer or a
network.
It comes with a LAN (network) interface
connector and a USB interface connector as
standard. A LAN cable can be used to connect
to a network, while a USB cable can be used to
connect to a computer.
LAN Cable Connection
When the printer is connected to a LAN
(Ethernet*) or other network, it can be shared
by the computers on the network.
* This printer is equipped with a network interface compatible
with 10BASE-T/100BASE -TX/1000BASE-T as standard.
Windows
Windows
Windows
Windows
Hub
Note
z
Connect the cable after completing the settings of this
printer.
z
If the cable is routed in front of the device, use the cable
clamps attached to the unwinder.
z
Passing cable through the clamps avoids problems with
unwinder operation.
Things to Prepare
LAN cable
Hub
Note
z
The printer does not come with a LAN cable or hub. If you
need a LAN cable (Category 5e or higher, twisted cable,
straight) and hub, it is up to you to prepare them.
z
The initial factory defaults setting of the Admin Setup
is "Gigabit network: Disabled." This setting needs to be
changed in order to use a 1000BASE-T connection.
Setting Procedure: On the control panel, input your
password in [Admin Setup], and then select [Network
Setup] > [Gigabit Network] > [Enable].
To Connect a LAN Cable
1
Connect the LAN cable to the printer's
LAN (network) interface connector (
①
).
LAN
(network)
interface
connector
LAN cable
①
2
Connect the other end of the LAN cable
to a hub connector (
②
).
LAN cable
②
