Oki POCKET PRINT 6010E, User Manual

Page: 170 / 230

IV - 80
Section IV - TCP/IP
OKI OkiLAN 6010e User’s Guide
Prerequisites
Before you proceed, the following prerequisites must be
met. Most of the time, steps 2 through 5 are already
configured since the HP-UX system is on a TCP/IP
network. Do not perform steps 2 through 5 unless the
installation procedure fails!
1. The name OKIPRINTER and the IP address
assigned to the OkiLAN 6010e are in the “/
etc/hosts” file on the HP-UX system.
2. Make sure the rlp process is not running by
typing at the UNIX prompt:
ps –e | grep rlp
If rlp is not running, you will not see any
output after executing this command.
If rlp is running (that is, if you see output
after executing this command), kill the
process with the command:
kill –15 process_number
3. Make sure the following entry is in the “etc/
inetd.conf” file:
printer stream tcp nowait root /usr/lib/
rlpdaemon rlpdaemon –i
If the rlp daemon is not running when a print
request is made, this entry in “/etc/
inetd.conf” tells inetd to auto-start the rlp
daemon to service the pending print request.