42114101 Rev.1
71 /
5
2
3
1
4
A
3.3.14 Operation Panel Board (LEOP)
(1)
Remove the upper cover (see 3.3.4 (1) – (5)).
(2)
Disconnect the cable
1
from connector
3
of Control Board
2
.
(3)
Disengage claws on both sides from the frame, and remove the operation panel
4
.
(4)
Open claws (4 places) and remove the operation panel Board
5
from the operation panel
4
.
(5)
To install, follow the removal steps in the reverse order.
Note on installation:
(1)
Make sure that there is not any dust or oil on the connector contact section A. If it
is found, wipe it off by alcohol.
Summary of Contents for ML490 Series
