42114101 Rev.1
63 /
3.3.6 PC Connector
(1)
Remove the printhead (see 3.3.1).
(2)
Remove the upper cover (see 3.3.4 (1) – (5)).
(3)
Remove the gear case Assy (see 3.3.5).
(4)
Remove the PC connector
1
from the space motor Assy
2
.
(5)
To install, follow the removal steps in the reverse order.
Note on installation:
(1)
Do not touch the space motor
2
or terminals of PC connector
1
. Also, take care
to avoid dust or foreign matters.
(2)
After installation, check and adjust the gap between platen and printhead (see 4-1).
(3)
Make sure that there is not any dust or oil on the connector contact section A. If it
is found, wipe it off by alcohol.
1
2
(rear side)
A
Summary of Contents for ML490 Series
