- 47 -
8.15 ^BK ANSI CODABAR BAR CODE
Format: ^BKo,e,h,f,g,k,l
o = Font rotation
N : 0°
R : 90°
I : 180°
B : 270°
When omitted: Value of ^FW
* The point of origin differs depending on the coordinate designated in ^FT and ^FO.
e = Check digit
N : Invalid (fixed)
h = Bar code height (in dots)
203-dpi printer: LE840
1 to 800 dots
300-dpi printer: LE850
1 to 1200 dots
When omitted: Value of ^BY
*1 If the value after dot-to-mm conversion exceeds 100 mm, it is corrected to 100 mm.
*2 If 0, a string, or other value is selected, it is corrected to 10 dots.
f = Print interpretation line
Y : Printed
N : Not printed
When omitted: Y
g = Print interpretation line above code
Y : Printed
N : Not printed
When omitted: N
k = Start character
A, B, C, D, E, N, T, or *
When omitted: A
l = Stop character
A, B, C, D, E, N, T, or *
When omitted: A
*1 When data are set with ^SN and the parameter z of ^SN (add leading zeros) is N, ‘0’ at the
beginning of data will be deleted.
*2 The character type of the interpretation line is independent of the module width value of ^BY. Font
A is used in any case.
*3 To print the interpretation line above code, the interpretation line parameter (parameter f) needs to
be set to “Y.”
*4 When an invalid code is selected for the start/stop character, it is printed as ‘A.’
*5 When E, N, or T is selected for the start/stop character, the interpretation line is printed in lower-
case characters with Oki Data while it is printed in upper-case characters with Zebra.
*6 If the command is sent without setting data (only ^FS and ^XZ are set while ^FD^FS and ^FD are
not set), the barcode will not be printed.
