- 18 -
5.6 SELECTION OF PRINT SPEED
LE840/LE850
3 ips (G/T)
5 ips (T)
6 ips (G)
8 ips (T)
10 ips (G/T)
12 ips (G/T)
-
When 5 ips is selected for the 203-dpi printer, printing is performed at 6 ips, and when 8 inch/sec. is
selected, it is performed at 10 inch/sec. When 6 ips is selected for the 300-dpi printer, printing is
performed at 5 ips.
Among the Zebra commands, the ^PR command sets print speed. If the ^PR command is not sent to
the printer, print speed set by this parameter will be valid. To change the print speed, check this
setting first.
5.7 SELECTION OF MAXIMUM LENGTH
Select a number from 0 through 9 for an applicable digit by pressing the [FEED] or [RESTART] keys.
Pressing the [PAUSE] key determines the value for the selected digit, then the cursor moves to the next
digit. (After setting a value for the last digit, the maximum length takes effect and the next parameter is
shown.)
This value is used as the feed length for calibration.
NOTE:
The maximum label length that can be automatically calibrated is set, in the same way as the
MAXIMUM LENGTH provided in the system mode of the Zebra printer.
NOTE:
The maximum feed length is limited to 50 mm or more. When a value less than 50 mm is set, 50
mm is applied.
NOTE:
The recommended length is as follows:
10.0 mm to 177.8 mm (7 inches)
Therefore, the recommended maximum length is as follows:
10.0 mm to 360 mm
FEED
RESTART
FEED
RESTART
0
1
10.0 to 1500.0 mm
8
9
