- 121 -
8.82 ^JU CONFIGURATION UPDATE
Format
：
^JUa
a = Configuration
F : The system mode is restored to default and the printer is reset.
N : The network setting is restored to default (unsupported).
R : The operation conditions are restored to the ones saved in the system mode.
S : The current operation conditions are reflected to the system mode and saved.
When omitted: This command is ignored.
* If “N: The network setting is restored to default" is selected, this command is ignored.
*1 When the parameter a is set to “R: The operation conditions are restored to the ones saved in the
system mode” and the tilde (~), caret (^), and delimiter (,) symbols differ from the current operation
conditions, reset the printer to synchronize it with BASIC application.
*2 When the parameter a is set to “F: The system mode is restored to default and the printer is reset,”
the default value is the initial value of the system mode setting.
*3 The system mode setting items and the default values for them are shown below.
LABLE LENGTH
0105.0mm:
LABEL WIDTH
104.0mm:
RIBBON
WITTH RIBBON: LE840T, LE850T
WITHOUT RIBBON: LE840D
PRINT MODE
NO CUT
SENSOR
TRANS
PRINT SPEED
3 ips
MAXIMUM LENGTH
0500.0mm
POWER ON CALIB
CALIBRATE
HEAD CLOSE CALIB
CALIBRATE
DOT/MM
8dots/mm: LE840
12dots/mm: LE850
FORMAT CONVERT
NONE
CONTROL PREFIX
7E
FORMAT PREFIX
5E
DELIMITER CHAR
2C
LABEL SIZE(LL)
ENABLE
LABEL TYPE(MN)
ENABLE
MEDIA TYPE(MT)
ENABLE: LE840T/LE850T
DISABLE: LE840D
TONE ADJ(SD)
ENABLE
TONE ADJ(MD)
ENABLE
GRAPHIC POSITION
SPEED-ORIENTED
TAB -> SP
04
RFID ADJUST
+000.0mm
OFFSET PRINT
NONE
LABEL SHIFT
+000.0mm
