24
Replace the dust filters
Check that the suction fan filters are not encrusted with
dust.
Inside the Printer, exhaust fan filters also called dust filters are
attached to:
- the four air exhaust outlets of the suction fan with the IP-7900-
20/21; or
- the three air exhaust outlets of the suction fan with IP-7700-20/21
Replace all the dust filters approximately every three months.
Dust filters
When replacing the dust filters from the operation panel menu,
start the procedure from step 1. When replacing while executing
[#START MAINTENANCE]
, start the procedure in step 6.
You will be prompted to replace the dust filters during the start
maintenance guidance after 3 months or 2.5 km of print length.
1
á
R E W I N D
F O R M F E E D
â
ß
P H . R E C
P H . M A I N
à
Press the
key.
2
# S T A R T M A I N T E N A N C E
>
With the
key select [#MAINTENANCE].
3
# M A I N T E N A N C E
> S P I T T O O N C A S E / U N I T ?
Press the
key.
4
# M A I N T E N A N C E
* S P I T T O O N C A S E / U N I T ?
Press the
key.
5
# M A I N T E N A N C E
* D U S T F I L T E R ?
Select [DUST FILTER] and press the
key.
6
D U S T F I L T E R C H E C K E D ?
Y E S : O K / N O : C A N C E L
Press the
key.
7
When the media is installed on the take-up reel
unit, remove the media.
8
By spreading an unnecessary media or cloth on
the floor, prevent the floor from being smeared
with the ink clot dropped from the old suction
fan filters.
9
Remove the old suction fan filters from the hook-
and-loop fastener.
If the old filter’s lint is left on the hook-and-loop
fastener, remove it.