OKBABY 10+, Manual

Page: 8 / 59

10 11
ENGLIS
H
ENGLIS
H
Rear child‘s seat 10 + Rear child‘s seat 10 +
holes (8). When the seat is correctly in place, tighten the screws (9)
slowly and evenly until the fastening block stops rotating around the
frame. Slide the cover (14) over the front part of the fastening block
(8). Cover the counter-block (7) with the protection cover (13) (see
illustration 1).
Illustration 7:
Adjust the vertical and horizontal position of the child seat accord-
ing to parameters seen in the figure. The barycentre (see ill., red
ring) must not be over 10 cm behind the wheel axis. If necessary,
correct the horizontal position of the child seat as described in il-
lustration 8.
Illustration 8:
Correcting horizontal position.
Phase 1: Press the two halves of the locking pin handle together so
that the safety clip opens.
Phase 2: Turn the locking pin 90° downwards.
Phase 3: Move the child seat horizontally until you find the right
position.
Phase 4: Fix the support as shown in illustration 5.
Illustration 9:
Fastening the footrests: Place the footrest marked “SX” in the high-
est position of the seat’s left leg. Insert the regulating pin marked
“SX” from the outside of the child seat inwards. Repeat the opera-
tions for the right footrest and relative regulating pin, marked “DX”.
Using the seat:
Illustration 10:
Inclining the child seat: To set the inclination of the child seat, pull
the release knob (E) upwards. Hold the release knob upwards, and
with your other hand incline the seat to the desired position. Then
let go of the release knob.
Illustrations 11-12:
Moving the footrests. Rotate the regulating pin upwards and move
the footrest to the desired position. Once in the desired position,
block the footrest by rotating the regulating pin downwards.
Illustration 13:
Fasten the child’s safety belt: Adjust the height and length of the
belts according to the size of the child. Setting belt height: the belt
can be extracted to adjust its height by inserting the buckle behind
the backrest through the opening each time. Choose the upper or
lower openings to fix the belts based on the child’s height. Setting
belt length: modify belt length by sliding the buckles. The belts
must be fastened firmly without them being too tight for the child.
Fasten the belts: Fasten the belt clasp. Check that the belt clasp
clicks shut properly, and then pull the belt.
Illustration 14:
To unfasten the belt, simultaneously press the two buttons (front
and rear) found on the clasp. The clasp will open.
Illustration 15:
Fastening the footrest strap: Place the child’s foot inside the straps
and fasten them onto the hooks behind the brackets. To undo the
straps, unhook them and remove them from the bridges whilst they
are inclined.
Illustration 16:
Removing the child seat: Press the release button (1) of the fasten-
ing block (8) and remove the child seat. To hook the seat on again,
insert the support arm (5) in the two fixing block holes (8) until the
lever clicks (fig.6).
Maintenance
1) Clean the seat, the padding and the belts with warm water and a
mild detergent. Do not use solvents or abrasive or corrosive de-
tergents. Leave the padding to dry in the open air. Do not iron.
2) Seat repairs and replacement of damaged components must
only be carried out by authorized personnel.
Technical specifications
Product Child bicycle seat OKBABY mod. 10+
Dimensions 41x58x70 CM (LxDxH
Weight 3.7Kg