Oilon VSi 6-14, Installation And Operation Manual

Page: 51 / 74

ID Analog input
B1 Hot gas 1
B2 Not in use
B3 Storage tank upper section
B4 Storage tank lower section
B5 Outdoor temperature
ID Analog input
B6 Heating circuit 1 temperature
B7 Heating circuit 2 temperature
B8 Heating circuit 3 or DHW temperature
B9 Not in use
B10 Brine circuit temperature
Analog outputs
Analog output states ver. 1
ID Analog output
Y1 Heating circuit 1 valve
Y2 Heating circuit 2 valve
Y3 Analog 0–10 V, immersion heater
ID Analog output
Y4 Heating circuit 3 / DHW valve
Y5 Brine circuit pump
Y6 Desuperheater valve
5.4.3 Running information
The
Running information
view shows the compressor’s current status, such as OFF
or ON.
5.4.3.1 Heating circuit amount: the number of heating circuits
The
Heating circuit amount
view allows you to select the number of heating circuits
connected to the heat pump.
There can be 1-3 heating circuits; circuits 2 and 3 are optional accessories. If all three
heating circuits are in use, the
Domestic hot water limiter
function (see
Hot water
temperature limiter
and
Storage tank settings
) cannot be active.
5.4.4 Hot water temperature limiter
Use this view to activate the Hot water limiter function (optional accessory). This
function prevents domestic hot water temperature from reaching hazardous levels.
The view allows you to change the input for domestic hot water temperature sensor
and the output for the associated control valve (
position valve
).
● The standard setting for the DHW temperature sensor is B8.
● The standard setting for the analog control signal is is Y4.
M8011 2204EN 49 (70)