● Detach the hose by turning the freely-rotating nut while keeping the hose from
rotating from the other side. Do not open the compression fitting.
8. Detach the in-line heater’s (EB203) corrugated hose.
● Detach the hose by turning the freely-rotating nut while keeping the hose from
rotating from the other side. Do not open the compression fitting.
9. Remove the compressor unit’s fastening screws (M8), and pull the unit out.
● Leave the brine circuit’s piping attached to the unit.
Compressor unit fastening screws (EasyAce) ver. 1
Pulling out compressor unit ver. 1
Reinstall the components and connections in reverse order. Test the flat gaskets in the
water and brine connections, replace if necessary.
● Be careful when installing the domestic hot water sensor in its sensor pocket.
26 (59)
M8006 2314EN
