- 15 -
○
Operation Timing After Replacing the Main Motor
・
To adjust the timing of the scooping block in respect to the brush
movement, it is necessary to adjust the gear engagement.
・
When the motor has been removed from the main body, adjust the
gear engagement of the motor, as shown in the figure on the right
then the operation timing can be adjusted. After assembling the
motor, be sure to tighten the screws again.
・
When it is hard to engage the driving gear, of the motor with the
driven gear, loosen the drive shaft bracket (right) then this will
facilitate the assembly. (Refer to the figure on the right.)
・
After installing the motor, switch the power ON to check the
operation timing. (Check that both right and left scooping blocks
operate almost simultaneously.)
・
After doing an operation check, return the wiring arrangement to its
original status. When installing the cover, be careful not to pinch any
wires. Be careful that the wiring does not hinder the operation of
moving parts. The wiring, on the inside, should not hinder
adjustments made from the outside of the machine.
NOTE:
→ To avoid breakage, do not use excessive force with the motor
wiring.
・
Assemble the motor section when the scooping blocks left and
right are in the lowest position.
・
To get the left and right scooping blocks at almost the same
height, clinch the drive gear of the motor shaft and the gears
on the left and right, and tighten the motor bracket.
(M2.6 x 8 - 2 pieces)
When the right
pin is vertical, the
left pin should be
inclined about 46°.
The left and right scooping blocks should be at the lowest position.
Right driving shaft bracket
Attaching screws at 4
positions
When it is hard to get a proper gear engagement,
loosen the right driving shaft bracket then adjust the gears
and tighten the screws.
Turn OFF the power switch before starting to replace and adjust the
main motor.
