- 24 -
マウスピース
ビット
ネジ
ネジの頭の高さ
＋ 0.3mm
供給機の破損防止の
ための隙間
0
.
3
7
-
3
．
Robotic Operations
When the screw feeder is used with an automatic assembly system, in order to
avoid contacts between screw driver and screw feeder , please set the lowest
point of the bit at least 0.3mm above the screw, so that contact or collision of the
driver bit and screw feeder can be avoided.
Bit cover
Driver bit
Screw
0 . 3 m m a b o v e s c r e w
head to prevent collision
or damage to the screw
feeder
8
．
MISCELLANEOUS
8
-
１
．
Overload protective circuit
This machine is equipped with an overload protective circuit.
Normally, the driving motor rotates forward to feed screws to the escaper continuously.
However, if there is an overload at the driving section, the driving motor rotates backward for a certain amount of time and then returns to
normal rotation.
When the cause for the overload is removed, during the reverse rotation, the driving motor returns to the normal rotation.
If the cause of the overload is not removed, during the reverse rotation, the driving motor repeats the sequence of
reverse rotation/normal rotation, reverse rotaion/normal rotation to shut off the power to the driving motor.
During this time, the escaper action is not stopped.
When the power to the driving motor is shut off, turn OFF the power switch and remove the cause of the overload.
For example, when too many screws are loaded into the scooping chamber, reduce the quantity
of loaded screws to a proper level. If any screw is caught in the transport section, remove it.
After removing the cause of the overload, turn ON the power switch to operate the machine. (Power reset)
