EN 13 Ranger
™ 4000 Series
For menu items with numeric settings such as Capacity, the current
setting is displayed with all digits flashing.
Press the
No
button to begin editing.
The first digit is displayed flashing.
Press the
No
button to increment the digit or press the
Yes
button to
accept the digit and move to the next digit.
Repeat this process for all digits.
Press the
Yes
button when the last digit has been set.
The new setting is displayed with all digits flashing. Press the
Yes
button to accept the setting or press the
No
button to resume editing.
This method also applies to setting Checkweigh under and over
targets.
For End menu items, pressing the
Yes
button advances to the next
menu, while pressing the
No
button returns to the top of the current
menu.
4.2 Calibration Menu
Enter this menu to perform calibrations.
Initial Calibration
When the scale is operated for the first time, a span calibration is recommended to ensure
accurate weighing results. Before performing the calibration, be sure to have the appropriate
calibration weights as listed in table 4-1. Ensure that the LFT switch/calibration lock is set to
unlocked position. See figure 5-1.
Or adjust the GEO setting according to your location (see table 4-2).
Procedure:
Press and hold
Menu
until [
mMeNU
] (Menu) is displayed. When the button is released, the display
will show [
C.A.L
]. Press
Yes
to accept. [
SpaN
] will then be shown. Press
Yes
to begin the span
calibration. [
0
kg
] will be displayed. Press
Yes
to accept. [
--C--
] will be displayed while zero
reading is stored. Next, the display shows the calibration weight value. Place the specified
calibration mass on the pan. Press
Yes
to accept the weight or
No
to select an alternate weight.
[
--C--
] will be displayed while the reading is stored. The display will show [
done
] if the calibration
was successful. The scale returns to the previous application mode and is ready for use.
TABLE 4-1
Required Span Calibration Mass (sold separately)
Max
Mass
1
Max
Mass
1
3000g
3kg / 6lb
15000g
15kg / 30lb
6000g
6kg / 15lb
30000g
30kg / 60lb
Note:
1
Pound masses are used when calibrating in the lb unit.
Summary of Contents for Ranger R41MEB
Page 1: ...Ranger 4000 Series Instruction Manual...
Page 2: ......
