EN-6
Ranger™ Count 2000
Series
The colored LED indicators on the left side of the control panel are used in
Checkweighing mode (section 3.5) and will light up according to the following rules:
(Red) Loads > Upper limit
(Green)
Loads ≥ Lower limit and ≤ Upper limit
(Yellow) Loads < Lower limit
Figure 3-3. Below view of Ranger Count 2000
3.2 Turning Scale On/Off
To turn the scale on, press and hold the
On/Zero Off
button for 1 second. The scale
performs a display test, momentarily displays the software version, and then enters
the active weighing mode.
To turn the scale off, press and hold the
On/Zero Off
button until OFF is displayed.
3.3 Counting
Ranger Count 2000 has three display areas. Weight, Piece Weight and Count
information are displayed in these areas respectively.
3.3.1 Preset tare
Enter a value with the numeric keypad. The value will be displayed in the Count
window.
Pressing
Tare
key, the value in current unit will then be saved as the preset tare.
To clear the tare value, clear the pan and press
Tare
key.
Power Input
Weigh Below
Access
Lock Switch
RS232
Interface Port
(below cover)
