TROUBLESHOOTING
Page 41 of 53
SERVICEMANUAL
© OHAUS Corporation
• Put in the new rotor sensor, plug in all electrical connections and re-assemble the
unit in reverse order.
3.13 Replacing the temperature sensor (FC5816R only)
• Remove the front covering of the front housing as described in chapter 3.1.
• Remove the electrical supply on the control board.
Figure 2
• Remove the motor rubber covering by pulling it out simply.
• Pull out the temperature sensor from the rubber motor cover. Hold therefore the
underneath rubber nose, which held the sensor housing in its position. Press
afterwards the rubber nose together and push it towards the hole.
• Reassemble the unit in reverse order.
