33
ofs.com
imagine a place®
800.521.5381
Assembly instructions
Obeya assembly instructions
1. Attach mounting bracket to roof beam
extrusion with (2) 5/16-18 x 2.5" FH bolts from
the outside face and (2) 5/16-18 hex nuts from
inside the extrusion.
2. Assemble 2 rectangle nuts to each mounting
bracket as shown using #8-32 x 3/4" machine
screws through top of bracket.
3. Insert roof beam into structure from inside
lifting one end up at an angle over the upper
extrusion far enough to lift the other end of the
roof beam above its mating extrusion.
4. Set roof beam into place by aligning the
rectangle nuts in the mounting brackets with
the inside slot in the supporting extrusion
and lowering the roof beam so the roof beam
bracket rests on the top face of the structure's
upper extrusion at each end.
5. Locate roof beam centered in the ceiling
opening and secure by tightening the two
#8 x 3/4" machine screws in each
mounting bracket.
6. Attach bottom trim rail & route electrical
components as needed in the roof beam
and mount any receptacles before hanging
the cladding panels (see trim rail & cladding
installation sheets for reference)
Note:
Easily locate
roof beam by aligning
notch in mounting
bracket with cutout
in extrusion
Rectangle nut
#8-32 x 3/4"
Machine screw
Roof beam
extrusion
Roof beam assembly
5/16-18 x 2.5" FH bolt
Mounting bracket
Roof beam attachment
