Important notes
Knee immobilisation splint 0°/20°
The Dynamics knee immobilisation
splint
provides optimum immobilisation of
the knee joint in the straight (0° version) or
bent position (20° version) The skin-friendly
terry cloth material on the inside guaran-
tees enhanced wearing comfort. The open
design facilitates putting on and taking off
the splint, thus simplifying personal hygiene
and wound treatment.
Dear user,
We are pleased that you have chosen a
product from Ofa Bamberg and would like
to thank you for putting your trust in us.
Please take a moment to read through this
product information carefully to ensure
optimum effectiveness of your Dynamics
product.
Ofa Bamberg wishes you a speedy
recovery!
←
Fitting instructions
The fi tting instructions in pictures can be found on the fold-over page at the be-
ginning of the brochure.
1
In order to put on the splint, open all Velcro fasteners and open up the cuff completely.
The lateral parts are individually adjustable. Adjust them so that the cuff encloses the
leg completely.
2
When putting the cuff on, please note that it becomes narrower at the lower end. Put the
splint against the back of your leg. First close the Velcro fastener directly below the knee
by pulling the tape through the corresponding eyelet and fastening it down. Then close the
Velcro fastener above the knee. The splint is positioned correctly when the kneecap is in the
corresponding opening of the cuff.
3
Now close all Velcro fasteners one after the other. The Velcro fasteners can then, if necessary,
be adjusted until the splint is correctly positioned. Please ensure that the product is secure
but not too tight in order to prevent pinching.
